Specifically designed to protect 99% of all substrates, restore and extend asset life for facilities operating in the harshest of conditions, MAD Armor coating is water based, mold and mildew resistant, acid resistant, rust preventative, very low VOC, waterproof, vapor barrier, non-toxic and flame retardant.
MAD Armor has a 700% elongation, 1,500 PSI tensile strength and can be used to coat, insulate and protect hot/cold piping, drains, flexible insulation, HVAC units, cooling towers, fan rooms, plenums and ducts.
Non-skid and non-toxic product used for flooring works in the harshest interior and exterior environments. MAD Shark coats, insulates, protects and makes safe floors, galley, service areas, fan rooms, generator rooms, walkways ladders, steps, stairs.
Respect epoxy flooring, this product has superior strength and doesn't crack or fade due to theunderlying coating technology and its flexing ability. MAD Shark is derived from MAD Armor by the addition of aluminum oxide particles and has a sliding coefficient (COF) of 0.6 for flat walk surfaces and of 0.8 for inclines and ramps.
Derived from MAD coating, this product is designed to provide additional safety and slip resistance for exterior railings in exposed Marinas, boardwalks, walkways and pool environments. MAD grip is water based, mold and mildew resistant, acid resistant, rust preventative, very low VOC, waterproof, vapor barrier, non-toxic and flame retardant. It can be used to coat, insulate and protect hand rails, stairs, balconies, marinas, ramps and walkways.
Derived from MAD coating, this product is designed to fill and repair surfaces and it's reinforced with chopped fiberglass strands. MAD Fiber can be built up and it's mainly used to repair and build up HVAC insulation blankets and repair small pin hole corrosion points in ducting. Once that MAD Fiber is applied and dried, MAD Armor or MAD Shark may be applied as top coat to finish the surface as required.
MAD Bond is used to coat porous substrates when priming for topcoat. Applied directly over porous substrates to enhance adhesion of MAD Armor and MAD Shark. In most cases the coating is applied (brushed, rolled or sprayed) directly over mold and mildew or directly over rust.
MAD Defense converts rust to non-corrosive substrate and can be used to treat, coat and protect existing rust problems. Applied directly over the rust area.
Nanotechnological photocatalysis guarantees:
high degree of conservation of the original structure
cleaning without the use of chemicals
self-cleaning and water-repellent action
antimicrobial disinfectant action
degradation of organic compounds
neutralizing action of odors
You just found it, now make the quality leap
A multidisciplinary team that grows since 2009
Vat number IT01905060990
Company capital 40,000€
Company with sole shareholder
REA 444.291 GE
Via Pietro Leva 60, 16153, Genoa (Italy)
Via Molo Cagni, 16128, Port of Genoa
+39 010 302.78.02 | +39 010 302.60.97
Global Assistance 24/7/365
We are ready to gain your trust